What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 30.06.2025 02:56
There are two important concepts here.
But it can get overloaded, and no longer works.
This is 'the assistant's answer'
My Husband and I Need Advice/Help - Daily Kos
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
I post the exact comment here.
If books could kill: The poison legacy lurking in libraries - BBC
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Do empaths fall easier for abusive people?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
At one ohm, the resistor has a maximum of 1 watt power.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
These devices are installed between the “hot” and “neutral” and protective ground.
So, the voltage could go up to 500 volts, and the fuse will not open up.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The #1 Anti-Inflammatory Diet Habit You Should Start, According to Dietitians - EatingWell
An AC voltage/ current source, and an ac inductive load.
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
What drove the tech right’s — and Elon Musk’s — big, failed bet on Trump - vox.com
A circuit breaker is similar, but is resettable.
What is lightning?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2 major cancer breakthroughs just dropped, and doctors are buzzing - Business Insider
One is “what exactly is in a ‘surge protector’ ? ”
nine
Barnstars:
Former Clemson DB on College Football Hall of Fame ballot - TigerNet
First Sentence:
so, what happens?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
A fuse is a non-resetable over current circuit protector.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The other is “what does a “fuse” do?”
How John Cena recreated CM Punk’s Pipe Bomb promo and changed his farewell tour - Cageside Seats
Because the load is inductive, the current lags the voltage.(by a bit).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
The third is lightning and “how it gets conducted into a home.”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
but this device (an Inductor) … impedes the rapid changes in the current.
He then asserts :
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
(Dc diagram shown, AC is similar).
2024–10–10[John johnson John Johnson ]
[image of Common-mode choke]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
[old diagram got deleted by accident]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is where the MOV conducts again, and dissipated the energy.
the problem then depends on "how fast does the fuse operate?".
The bolt then partially travels down the line to your home.
There are three different concepts here that are getting confused.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
For this case there are devices called Metal oxide varistors (MOV).
These are simplified answers to the original question, and does not change anything I wrote above.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Edit 2024–10.
This is where this question deviates from being a 'generic' question, and becomes more specific.
eight
what exactly is a ‘surge’ protector?
but I think this circuit , shows a few more pieces.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–16 [ OO OLAOYE OYEBODE ]
a photo is worth a thousand words.
Here is a simplified AC power diagram.
Upvotes:
He then describes the function of a fuse.
This device then solves the entire problem.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What does a fuse do?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
At least they know the answer if they wanted it.
One
In schematic diagrams this is the symbol for a fuse:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes Rainy Season and Lightning.